Application Of The Basic Program - Siemens SINUMERIK 840D sl Function Manual

P3: Basic PLC program for SINUMERIK 840D sl
13.7 Starting up the PLC program
References
CNC Commissioning Manual: NCK, PLC, Drive; Section: "Commissioning PLC" > "Creating a
PLC program"
Note
Installation/update
Before installing the toolbox for SINUMERIK 840D sl, SIMATIC STEP 7 must be installed.
It is recommended that the hardware expansions for STEP 7 be installed again from the toolbox
after an update of STEP 7.
Contents
The OB source programs, including standard parameterization, interface symbols and data-
block templates for the handheld unit and M decoding functions are included in the basic
program.
13.7.2

Application of the basic program

A new CPU program (e.g. "Turnma1") must be set up in a project by means of the STEP 7
software for each installation (machine).
Remark
The catalog structures of a project and the procedure for creating projects and user programs
are described in the relevant SIMATIC documentation.
Procedure
The basic program blocks are copied using the SIMATIC Manager and
"File" > "Open" > "Library".
The following components must be copied from the library:
● From the block container: FCs, FBs, DBs, OBs, SFC, SFB, UDT
● The source_files (from the source container): GPOB840D
● Possibly MDECLIST, HHU_DB and others
● The symbols table (from the symbols container)
Compatibility with STEP 7
There are no dependencies between the basic program and current STEP 7 versions.
826
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions