How To Change User Preferences - Fluke MultiFiber Pro User Manual


Modes for the source (to see the menu, hold down
for 2.5 seconds):
 SCAN ALL ON: The source changes the channel
automatically.
SCAN ALL OFF: You press
the channel.
 AUTO 
: ON: The source transmits a wavelength
identifier that a MultiFiber Pro meter can read.
OFF: The source does not transmit a wavelength
identifier because the source is in 2 kHz mode. See
page "Auto Wavelength Function" on page 11.
 MODE 2 kHz: The output is a 2 kHz modulated
optical signal. Use this mode to identify fibers at
patch panels. See "How to Identify Cables or Fibers"
on page 24.
 SET 
: Lets you change the wavelength when AUTO

is OFF.

Shows the channel that is active.

CHANNEL: When SCAN ALL is OFF, press
to change the channel.

Numeric display for the wavelength.

   
or to change
   
or

How to Change User Preferences

 
: When the batteries are low, the low battery icon
flashes.
How to Change User Preferences
Table 2 describes the user preferences you can set for the
meter and source.
To set user preferences for the meter or source
1 For the meter: Make sure the meter is in power or loss
measurement mode.
For the source: Make sure the source is in signal output
mode.
 
2 Hold down and
3 To change a setting, press
shows.
4 To see the next setting, press
5 To save the settings and exit setup mode, hold down
 
and for 2.5 seconds.
together for 2.5 seconds.
   
. Or press if

.
9