Glass Specifications; Electrical Rating; Mobile Home Approved; Sleeping Room - Quadra-Fire CLASSIC BAY 1200 Owner's Manual

Hide thumbs Also See for CLASSIC BAY 1200:
Table of Contents

Advertisement

CB1200 Free Standing
C. Glass Specifications
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please
contact your dealer for replacement glass.
D. Electrical Rating
115 VAC, 60 Hz, Start 3.75 Amps, Run 1.88 Amps.
E. Mobile Home Approved
This appliance is approved for mobile home 
installations when not installed in a sleeping room and
when an outside combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling, 
and walls must be maintained.
The appliance must be properly grounded to the frame 
of the mobile home and use only Listed pellet vent 
Class "L" or "PL" connector pipe.
Outside Air Kit, part 811-0570 or 811-0872  must be 
installed in a mobile home installation.
F. Sleeping Room
When installed in a sleeping room it is recommended that
3ft of vertical be installed prior to horizontally exiting the 
room and a smoke/CO alarm be installed in the bedroom. 
The size of the room must be at least 50ft³ per 1,000 Btu/hr 
stove input, if the stove exceeds the room size, outside air
must be installed.
G. California - Prop65
WARNING
This product and the fuels used to operate this product (wood), and
the products of combustion of such fuels, can expose you to
chemicals including carbon black, which is known to the State of
California to cause cancer, and carbon monoxide, which is known to
the State of California to cause birth defects or other reproductive
harm. For more information go to: WWW.P65Warnings.ca.gov
8
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be 
voided by, the following actions:
Installation and use of any damaged appliance.
Modification of the appliance.
Installation other than as instructed by Hearth & 
Home Technologies.
Installation and/or use of any component part not 
approved by Hearth & Home Technologies.
Operating appliance without fully assembling 
all components.
Operating appliance without legs attached (if supplied 
with appliance).
Do NOT Over fire - If appliance or chimney connector
glows, you are over firing.
Any such action that may cause a fire hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified 
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer
of this appliance, reserves the right to alter
its products, their specifications and/or price 
without notice.
7027-802C
WARNING
June 4, 2019

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents