Sony STR-DH810 Operating Instructions Manual page 98

HDMI
The source sound input to the HDMI
jack is not output from the receiver or
the TV speaker.
• Check the HDMI connection (page 24).
• You cannot listen to the Super Audio CD
by connecting HDMI.
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
• Be sure to use a High Speed HDMI cable
when you view images or listen to sound
during Deep Colour (Deep Color)
transmission.
The source image input to the HDMI
jack is not output from the TV.
• Check the HDMI connection (page 24).
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
• Be sure to use a High Speed HDMI cable
when you view images or listen to sound
during Deep Colour (Deep Color)
transmission.
The Control for HDMI function does not
work.
• Check the HDMI connection (page 24).
• Make sure "CTRL: HDMI" is set to
"CTRL ON" in the HDMI menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
• Repeat the procedures of "Preparing for
the "BRAVIA" Sync" if you change the
HDMI connection, connect/disconnect the
AC power cord (mains lead), or when
there is a power failure (page 56).
98
GB
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the "AUDIO OUT"
settings in HDMI menu to
– "TV+AMP" if you want to listen to the
sound from the TV speaker and receiver.
– "AMP" if you want to listen to the sound
from the receiver.
• When you connect the receiver to a video
component (projector, etc.), sound may
not be output from the receiver. In this
case, select "AMP".
• If you cannot listen to the sound of a
component connected to the receiver
– Change the input of the receiver to
HDMI when you want to watch a
program on a component connected via
HDMI connection to the receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
When the receiver is in standby mode,
there is no image or sound output from
the TV.
• When the receiver is in standby mode,
image and sound are output from the
HDMI component selected the last time
you turned off the receiver. If you are
enjoying other component, play the
component and perform the One-Touch
Play operation, or turn on the receiver to
select the HDMI component you want to
enjoy.
• Make sure "PASS THRU" is set to "ON"
in the HDMI menu if you connect
components not compatible with the
"BRAVIA" Sync to the receiver (page 56).