Tuning Into A Station; Direct Tuning - Sony STR-DH810 Operating Instructions Manual

Tuning into a station

automatically (Automatic
Tuning)
1
Press TUNER repeatedly to
select the FM or AM band.
2
Press TUNING + or TUNING –.
Press TUNING + to scan from low to
high; press TUNING – to scan from high
to low.
The receiver stops scanning whenever a
station is received.
Using the controls on the
receiver
1
Turn INPUT SELECTOR to select the FM
or AM band.
2
Press TUNING MODE repeatedly to select
"AUTO".
3
Press TUNING + or TUNING –.
In case of poor FM stereo
reception
If the FM stereo reception is poor and "ST"
flashes on the display, select monaural audio
so that the sound will be less distorted.
1
Press AMP MENU.
2
Press V/v repeatedly to select "<TUNER>",
or b.
then press
3
Press V/v repeatedly to select
"FM MODE", then press
4
Press V/v repeatedly to select "MONO".
5
To return to stereo mode, repeat steps 1 to 4
and select "STEREO" in step 4.
Tuning into a station directly

(Direct Tuning)

You can enter the frequency of a station
directly by using the numeric buttons.
1
2
3
4
5
If you cannot tune in a station
or b.
Make sure you have entered the right
frequency. If not, repeat steps 2 to 5. If you
still cannot tune in a station, the frequency is
not used in your area.
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
Press D.TUNING.
Press SHIFT.
Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 b 0*
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
* Press 0 for models of area code CEL, CEK
only.
Press ENTER.
You can also use MEMORY/ENTER on
the receiver.
Tip
If you have tuned in an AM station, adjust the
direction of the AM loop antenna (aerial) for
optimum reception.
47 GB