MULTIQUIP AR14H Operation Manual page 26

VIBRATION BUTTON
1. To begin the vibratory action, toggle the vibratory switch
located on the right side of the travel lever as shown
in Figure 24. This will generate 3,400 lbf. (15.1 kN) of
centrifugal force at a frequency of 4200 vpm (vibrations
per minute) to the front drum.
VIBRATION
SWITCH
Figure 24. Vibration Toggle Switch
2. To stop the vibratory action, toggle the vibratory switch
again.
WATER PUMP AND VOLUME CONTROL VALVE
When wetting of a surface is required, perform the following
procedure.
1. Turn on the water pump switch (Figure 25) to activate
the water pump. The water pump indicator will light.
WATER
PUMP
SWITCH
Figure 25. Water Pump Switch
PAGE 26 — AR14H RIDE-ON ROLLER • OPERATION MANUAL — REV. #3 (09/06/19)
2. A water volume control valve for the sprinklers is
provided. This control valve (Figure 26) is located
right below the travel lever. The valve controls the
water supply simultaneously to the front and rear drum
spray bars.
a. To increase water volume, turn the control valve
counterclockwise.
b. To decrease water volume, turn the control valve
clockwise.
WATER VOLUME
CONTROL VALVE
Figure 26. Water Volume Control Valve
OPERATION