MULTIQUIP AR14H Operation Manual page 19

Figure 6 shows the location of components and controls
(3 of 3) for the AR14H compaction roller. The function of
each component or control is described below:
36. Battery — Provides +12VDC to the electrical system,
and is located underneath foot plate. Replace only with
recommended type battery.
37. Water Filter — Filters the water in the water pump.
38. Water Pump — Provides pressure to the water
sprinklers to allow even distribution of water on the
drums.
39. Fuel Shut-Off Valve — Stops the flow of fuel.
40. Accessory Relay — Provides the +12VDC necessary
to run the electrical accessories.
41. Fuse (10 Amp) — Povides overcurrent protection for
the water pump.
42. Fuse (30 Amp) — Provides overcurrent protection for
the starter.
43. Fuse (20 Amp) — Provides overcurrent protection for
the 12V outlet.
44. Articulating Locking Latch — Secures the front and
rear sections of the roller when lifted during transport
and maintenance.
45. Ignition Switch — With key inserted, turn clockwise
to start the engine.
46. Engine Oil Drain — Used to drain oil from the engine.
47. Engine — This unit incorporates a HONDA
GX630RHKAF, air-cooled engine rated at 20 hp at
3,200 rpm.
AR14H RIDE-ON ROLLER • OPERATION MANUAL — REV. #3 (09/06/19) — PAGE 19
48. Charcoal Canister — Keeps gasoline from evaporating
into the atmosphere. The carbon in the canister absorbs
the fuel vapor.
49. Hydraulic Oil Filter — Filters return oil from the front
and rear hydraulic motors.
50. Hydraulic Pump — This unit incorporates an axial
variable displacement hydraulic piston pump.
51. Gear Pump — Controls vibration and steering.
52. Hydraulic Manifold — Aluminum block that controls
the flow of hydraulic pressure to the various hydraulic
motors and other components required to control the
roller.
53. Hydraulic Motor — This hydraulic motor controls the
rotation of the vibratory system.
54. Hydraulic Fluid Filler Port — Remove this cap to
add hydraulic fluid. Fill with type ISO 46 anti-wear
hydraulic fluid.
55. Hydraulic Oil Level Indicator — Indicates the amount
of hydraulic oil present.
56. Hydraulic Oil Drain — Used to drain used hydraulic
oil when oil replacement is necessary.
57. Steering Cylinder Grease Zerk Fitting — Grease
this fitting biweekly. See maintenance section of this
manual.
58. Steering Cylinder — Controls direction of roller.
59. Documentation Canister — Store and maintain
Operation, Parts, and Engine manuals in this container
at all times.
COMPONENTS