MULTIQUIP AR14H Operation Manual page 33

Figure 33 shows the removal of the exciter assembly from
the right side of the front drum.
STEP 1
COVER
STEP 2
1. JACK FRAME UP SLIGHTLY AT ARTICULATION
JOINT.
2. REMOVE 4 ALLEN HEAD SCREWS HOLDING THE
COVER OF THE DRUM SUPPORT PLATE AND
REMOVE COVER.
5. REMOVE 6 NUTS SECURING THE 3
SHOCK MOUNTS TO THE SUPPORT
PLATE. REMOVE THE SUPPORT
PLATE.
NOTE: MOTOR OR SHOCK MOUNTS
CAN BE REMOVED AND REPLACED
AT THIS POINT.
6. REMOVE THE 6 BOLTS SECURING
THE EXCITER PLATE TO THE
DRUM WALL.
7. PULL EXCITER ASSEMBLY TO
REMOVE FROM DRUM INTERIOR.
8. REVERSE PROCEDURE TO
INSTALL EXCITER ASSEMBLY
AND REASSEMBLE DRUM. USE
LOCKTITE 271 ON ALL BOLT
THREADS.
Figure 33. Exciter Assembly Removal/Installation (Front Drum - Right Side)
AR14H RIDE-ON ROLLER • OPERATION MANUAL — REV. #3 (09/06/19) — PAGE 33
STEP 4
3. MARK AND DISCONNECT HOSES FROM MOTOR
4. REMOVE FOUR BOLTS FROM DRUM SUPPORT
EXCITER PLATE
MOTOR
STEP 5
MAINTENANCE
STEP 3
AND MANIFOLD.
PLATE. (BOLTS MAY NEED TO BE HEATED TO
REMOVE).
FRONT DRUM
STEP 6
SHOCK MOUNTS
DRUM
SUPPORT
PLATE
STEP 7
EXCITER
ASSEMBLY
DRUM
WALL