Lexmark MX81 Series Service Manual page 193

Action
Step 7
Remove the staple finisher assembly from the printer. Check the feed
rollers and gears under the staple finisher.
Is if free of damage?
Step 8
Open the top cover, check the left media stack flap:
• for damage
• if it is not dislodged from its original position
• if it has no problem moving when manually actuated
Is the above component ok?
Step 9
Check the right media stack flap:
•
for damage
•
if it is not dislodged from its original position
•
if it has no problem moving when manually actuated
Is the above component ok?
Step 10
Open the left cover, reseat all connectors on the controller PCBA and then
POR the machine.
Does the error remain?
Yes
Go to step 8.
Go to step 9.
Go to step 10.
Replace the controller
PCBA. Go to
offset stacker
controller PCBA
removal" on page
613.
If the error persists,
then replace the staple
finisher. Go to
finisher/offset stacker
option removal" on
page
Diagnostic information
193
No
Replace the staple
finisher assembly. Go
to "Staple finisher/
offset stacker option
removal" on page
595.
Replace the left media
stack flap. Go to
"Media stack flap (left)
removal" on page
603.
Replace the right
media stack flap. Go to
"Media stack flap
(right) removal" on
page 602.
The problem is solved.
"Stapler/
"Staple
595.
7463