Replacing The Paper Roll - Ingenico Move/5000 Quick Reference Manual

21 – Replacing the Paper Roll
When coloured stripes appear on a receipt, this is the indication to
change the paper roll.
NOTE:
To change the paper roll, follow the steps below:
1. Pull up the flap at the top of the terminal.
2. Pull the flap backwards to open the paper compartment.
3. Place the paper roll into the paper compartment. Make sure
the end of the paper is inserted as shown below. Pull a little bit
of paper out towards the top of the terminal. Close the paper
compartment by pulling the flap up towards the terminal.
Only use paper approved by the
manufacturer (roll diameter max 40
mm/1.57", roll width 58mm/2 ¼", roll length
17m/55'). Using unapproved paper can
damage the terminal's printer.
33