Running a System Test
If The System Test Reports
Any Problems...
72
Chapter 6: Using the Installation Menu
The System Test lets you check the integrity of your system's
components, including:
Y
Antenna signal
Y
System tuning
Y
Phone line
Y
Access card
Use the System Test if you are experiencing problems with your
system.
To run the System Test:
1
Select RUN SYSTEM TEST from the Installation Menu.
2
Select TEST.
RUN SYSTEM TEST
SIGNAL
TUNING
PHONE
CARD
The System Test checks all the components automatically, and
displays the result of each test.
3
Select RETURN to return to the Installation Menu.
Check your system for any of the following:
Y
The access card test will fail if you have not yet called your
program providers to establish service. After your service has been
established, the access card test should pass.
Y
Check that all cables are connected properly to the DSS receiver.
Y
Check that the satellite antenna is installed correctly, and that the
signal has been optimized. See the manual that came with the
satellite antenna for details.
Y
Check that the phone line connected to the DSS receiver is working
properly.
Y
Check that the access card is inserted properly.
If you cannot resolve problems reported by the System Test, see
"Customer Support" on page 2.
TEST
RETURN
HELP