Sony SAT-A1 Operating Instructions (primary manual) Operating Instructions Manual page 62

Changing the Default
Data Service
Selecting CANCEL returns you to the
previous screen, without saving your
selections.
The titles of the data services may be
different, based on the service being
provided.
Setting the Baud Rate
Selecting CANCEL returns you to the
previous screen, without saving your
selections.
The baud rates displayed may be
different, depending on which data port is
being used.
62
Chapter 5: Using the Custom Setup Menu
3
Select one of the following:
To Do This ...
Change the data service for the
current station only
Change the data service for all
stations
Change the baud rate for the DSS
receiver's wide band data port
Use the Default Data Services screen to select a default data service for
all stations that provide data services.
To change the data service for all stations:
1
Select DEFAULT from the Data Services screen.
2
Select a default data service and then select OK.
DEFAULT DATA SERVICES
DATA 1 DATA 2
DATA 5 DATA 6
To set the baud rate for the DSS receiver's data ports:
1
Select BAUD from the Data Services screen.
2
Select a baud rate for the data port and then select OK.
SET BAUD RATE
2400 4800
Do This ...
Select the data service and then
select OK.
Select DEFAULT (then see
"Changing the Default Data
Service" below).
Select BAUD (then see "Setting
the Baud Rate" below).
DATA 3 DATA 4
DATA 7 DATA 8
9600 19200
OK
CANCEL
HELP
OK
CANCEL
HELP