Home Entertainment System (Hi-Fi Tv, Hi-Fi Vcr, Audio/Video Receiver) - Sony SAT-A1 Operating Instructions (primary manual) Operating Instructions Manual

Home Entertainment System
(Hi-Fi TV, Hi-Fi VCR, Audio/Video Receiver)
Some VCRs label this jack RF IN,
instead of VHF/UHF IN.
20
Chapter 3: Connecting Your System
Refer to the illustration on the opposite page.
1
Connect the RG-6 cable from the satellite antenna's LNB to the DSS
receiver's SATELLITE IN jack.
2
Connect the DSS receiver's A/V jacks to the VCR and A/V
receiver's A/V IN jacks.
3
Connect the VCR's A/V OUT jacks to one set of the A/V receiver's
A/V IN jacks.
4
Connect the A/V receiver's MONITOR OUT jack to the TV's
VIDEO IN jack.
5
Connect one end of the telephone line cord to the DSS receiver's
TEL LINE jack. Connect the other end to your home's modular
telephone outlet.
6
Connect one end of the AC power cord to the DSS receiver's AC IN
jack. Connect the plug end to an AC outlet.
Optional Connections
Y
If you have a cable input, cable box, or a terrestrial TV antenna,
connect it the VCR's VHF/UHF IN jack.
Y
Best Connection: If your TV has an S-VIDEO jack, use an S-VIDEO
cable to connect the DSS receiver's S-VIDEO jack to the TV's
S-VIDEO IN jack. This provides the best picture quality. Then use
audio cables to connect one set of the DSS receiver's audio jacks to
the A/V receiver's AUDIO IN jacks.
Note
In this configuration, the A/V receiver must be turned on in order to pass the
video signals through to your TV. When watching a program that is protected
by Macrovision, turn the VCR off to ensure a quality picture.