Tv Only - Sony SAT-A1 Operating Instructions (primary manual) Operating Instructions Manual

Digital satellite system
Hide thumbs Also See for SAT-A1 Operating Instructions (primary manual):
Table of Contents

Advertisement

TV Only

TV With RF Connector Only
Some TVs label this jack RF IN,
instead of VHF/UHF IN.
Satellite Receiver
SATELLITE IN
LOW SPEED DATA
1
RG-6 Cable
from LNB
14
Chapter 3: Connecting Your System
Refer to the illustration below.
1
Connect the RG-6 cable from the satellite antenna's LNB to the DSS
receiver's SATELLITE IN jack.
2
Connect the DSS receiver's VHF(SAT)/UHF OUT jack to the TV's
VHF/UHF IN jack.
Note
A VHF/UHF connection does not provide stereo sound. To receive stereo
sound, you must use an A/V connection (described on page 15).
3
Connect one end of the telephone line cord to the DSS receiver's
TEL LINE jack. Connect the other end to your home's modular
telephone outlet.
4
Connect one end of the AC power cord to the DSS receiver's AC IN
jack. Connect the plug end to an AC outlet.
RF REMOTE
AUDIO
R
L
CONTROL S
AUDIO 3
IN
OUT
R
L
WIDE BAND DATA
(MONO)
OUT
Optional Connections
Y
If you have a cable input, cable box, or a terrestrial TV antenna,
connect it to the DSS receiver's VHF/UHF IN jack.
Y
To connect the DSS receiver to your audio system, use audio cables
to connect the DSS receiver to your audio receiver's AUDIO IN
jacks.
VHF/UHF
VIDEO S VIDEO
IN
CH 3
CH 4
VHF(SAT)/UHF
TEL LINE
OUT
2
3
Coaxial
Telephone
Cable
Line
VHF / UHF
AC OUT
AC IN
4
AC Cord
TV

Advertisement

Table of Contents
loading

Table of Contents