Table of Contents
Advertisement
Running a System Test
The System -i0st lets you check the integrity
of your system's
components,
including:
_1 Antenna
signal
System tuning
Phone line
Access card
Use the System Test if you are experiencing
problems
with your
system.
To run the System Test:
1
Select RUN SYSTEM TEST from the Installation
Menu.
2
Select TEST.
RUN SYSTEMTEST
I SIGNAL
I TUNING
I PHONE
I
CARD
I
I
r
I
ff-_
The System Test checks all the components
automatically,
and
displays
the result of each test.
3
Select RETURN to return
to the Installation
Menu.
If The System Test Reports
Any Problems...
Check your system for any of the following:
The access card test will fail if you have not yet called your
program
providers
to establish
service. After your service has been
established,
the access card test should pass.
Check that all cables are connected
properly
to the DSS receiver.
Check that the satellite antenna
is installed
correctly, and that the
signal has been optimized.
See the manual
that came with the
satellite antenna
for details.
_1 Check that the phone line connected
to the DSS receiver is
working
properly.
Check that the access card is inserted
properly.
If you cannot resolve problems
reported
by the System Test, see
"Customer
Support"
on page 2.
Chapter 6: Using the Installation
Menu
63
Advertisement
Table of Contents
