Installing The Projector; Installing The Srx Controller In A Computer For Controlling The Projector; System Requirements; Installing The Srx Controller - Sony SRX-T105 Operating Instructions Manual

Caution
Do not turn the spanner forcibly when the screw has fully
rotated. Otherwise, the spanner may slip and injure your
hand.

Installing the Projector

This section describes briefly how to install the projector
on the floor. The distance between the center of the lens
and the screen varies depending on the optional lens
attached, the horizontal screen size or the input signal.
For details on installation examples with projection
distances, see "Installation Manual for Dealers".
Screen
5
320 mm (12
Projection distance
Vertical positioning (side view)
Install the projector so that the center of the lens is between
the bottom edge and the top edge of the screen. You can
move the picture position vertically by half of the screen
vertical size using the lens shift adjustment.
For details on the lens shift adjustment, see page 30.
Center of lens
Screen
Horizontal positioning (top view)
Install the projector so that the center of the lens is aligned
horizontally with the center of the screen.
Screen
/ inches)
8
Adjustable range with lens
shift feature
Center of lens
Installing the SRX
Controller in a Computer
for Controlling the
Projector
If you install the supplied SRX Controller in a computer,
you can control the projector from the computer.

System Requirements

The following are required to operate the supplied SRX
Controller.
• Computer: Intel Pentium M 1.6GHz or higher, and a
recommended CPU in your Operating System
– Installed memory: 256 MB or more (512 MB or more
recommended), and recommended memory in your
Operating System
– Communication: LAN (10BASE-T/100BASE-TX) or
COM (RS-232C)
– VGA: XGA (1024 × 768) or higher
– HDD: Connected to a computer via the IDE port,
Usable memory with 15 MB or more
– CD-ROM drive: × 8 or faster
• Operating System: Microsoft Windows XP Professional
SP2 (English or Japanese version) (excluding ×64
Edition)
Intel and Pentium are registered trademarks of Intel Corporation in
the United States and other countries.
Microsoft and Windows are registered trademarks of Microsoft
Corporation in the United States and other countries.

Installing the SRX Controller

1
Insert the supplied installation disc into the CD-ROM
drive of a computer.
The setup.exe in the root folder of the installation disc
starts, and the window for preparing the installation
appears.

Installing the SRX Controller in a Computer for Controlling the Projector

15