Signal Info (Information); Signal Adjust - Sony SRX-T105 Operating Instructions Manual

compliance, or "10bit Twin Limited" or "10bit Single
Limited" for a signal of Limited Range compliance.
When the LKRI-001 is installed
Select "YPbPr" to input a high-definition signal from
component equipment, and "RGB" to input a high-
definition signal from video GBR equipment.
When the LKRI-003 is installed
For Single-link input, select "YPbPr" or "YPbPr
FULL".
For Dual-link input, select "RGB" or "RGB FULL".
When "RGB" or "YPbPr" is selected, in the case that
a 10-bit HD-SDI signal is input and "Contrast" is set
to 90 in "Signal Adjust" of the PICTURE CONTROL
window, mapping is done so that HD-SDI signal data
1)
values of 64 to 960 are converted to the video levels
of 0 to 100% to display an image on the projector.
When "RGB FULL" or "YPbPr FULL" is selected, in
the case that a 10-bit HD-SDI signal is input and
"Contrast" is set to 90 in "Signal Adjust" of the
PICTURE CONTROL window, mapping is done so
that HD-SDI signal data values of 0 to 1023 are
converted to the video levels of 0 to 100% to display
an image on the projector. In this case, inhibition
codes included in a 10-bit HD-SDI signal (data area 0
to 3, and 1020 to 1023) are blocked out.
1)
Data value 64 of a 10-bit HD-SDI signal input is
equivalent to the video level of 0% (black), and data value
960 equivalent to 100% (white).
I/P Mode: Selects the I/P conversion mode. Depending on
the input signal source, set the mode to "Interlace" or
"PsF".
Notes
• This item is available with the interlace or PsF
signal input.
• When the LKRI-004 or LKRI-005 is installed, this
item is not available.

Signal Info (Information)

Shows the horizontal and vertical frequencies of the input
signal automatically. The values are approximate.
The type of the input signal is also displayed.
fH: Displays the horizontal frequency.
fV: Displays the vertical frequency.

Signal Adjust

Adjusts the picture quality of the input signal.
Clicking increases the setting value, and
decreases it.
28
PICTURE CONTROL Window
Clicking the "RESET" button resets the following four
settings to the factory preset values.
Contrast: Adjusts the picture contrast. The higher the
setting, the greater the contrast.
Brightness: Adjusts the picture brightness. The higher the
setting, the brighter the picture.
Color: Adjusts the color intensity. The higher the setting,
the greater the intensity.
Sharpness: Adjusts the picture sharpness. The higher the
setting, the sharper the picture. The lower the setting,
the softer the picture.