Omron CJ-Series Operation Manual page 112

Built-in Outputs
Bit Allocations
Pulse Output Specifications
Code Word
address
OUT0 CIO 2961 00
OUT1 01
OUT2 02
OUT3 03
Item
Output mode
Positioning (independent
mode) instructions
Speed control (continuous
mode) instructions
Origin (origin search and ori-
gin return) instructions
Output frequency
Acceleration and decelera-
tion rates
Changing SVs during instruc-
tion execution
Duty ratio
Pulse output method
Number of output pulses
Pulse output PV's relative/
absolute coordinate specifica-
tion
Bit CW/CCW inputs
Pulse output 0 (CW)
Pulse output 0 (CCW)
Pulse output 1 (CW)
Pulse output 1 (CCW)
Specifications
Continuous mode (for speed control) or independent
mode (for position control)
PULS(886) and SPED(885), PULS(886) and
ACC(888), or PLS2(887)
SPED(885) or ACC(888)
ORG(889)
1 Hz to 100 kHz (1 Hz units from 1 to 100 Hz, 10 Hz
units from 100 Hz to 4 kHz, and 100 Hz units from 4
to 100 kHz)
Set in 1 Hz units for acceleration/deceleration rates
from 1 Hz to 2 kHz (every 4 ms). The acceleration
and deceleration rates can be set independently only
with PLS2(887).
The target frequency, acceleration/deceleration rate,
and target position can be changed.
Fixed at 50%
CW/CCW inputs or Pulse + direction inputs
The method is selected with an instruction operand.
The same method must be used for pulse outputs 0
and 1.
Relative coordinates: 00000000 to 7FFFFFFF hex
(Each direction accelerating or decelerating:
2,147,483,647)
Absolute coordinates: 80000000 to 7FFFFFFF hex
(−2147483648 to 2147483647)
Absolute coordinates are specified automatically
when the origin location has been determined by set-
ting the pulse output PV with INI(880) or performing
an origin search with ORG(889). Relative coordi-
nates are used when the origin location is undeter-
mined.
Section 5-2
Pulse + direction inputs
Pulse output 0 (pulse)
Pulse output 1 (pulse)
Pulse output 0 (direction)
Pulse output 1 (direction)
93