Dm860A Reboot Mode; Remote Id Setup Mode - Denon AVR-4520CI Service Manual

6.

DM860A Reboot mode

6.1. Specifications
• When DM860A is hung up, DM860A is restarted.
Even when Network standby is set (Setup Menu - Network - Network - Always ON), DM860A can be reset.
6.2. Operation
1. Turn on MAIN ZONE button, and select NETWORK for the input source.
2. Press and hold the "DIMMER" and "INFO" buttons for 3 seconds and longer.
3. DM860A is restarted and returns to the normal display.
FL display while DM860A is being restarted
N e t w o r k
Upper
Lower
NOTE:
The same operation cannot be accepted for one minute after the last 860 Reboot.

7. Remote ID Setup mode

7.1. Specifications
When using multiple DENON AV receivers in the same room, make this setting so that only the desired AV receiver
operates.
7.2. Setting the AV receivers
Starting up:
Turn on the power, then press and hold down the "STATUS" and "DIMMER" buttons for over 3 seconds.
(1) When Remote ID Setup mode is started, the following is displayed.
Upper
Lower
(2) Press the "QUICK SELECT 1 - 4" button that corresponds to the number you want to set.
Button
QUICK SELECT 1
QUICK SELECT 2
QUICK SELECT 3
QUICK SELECT 4
(3) Turn off the power using "Power operation ( X )" button.
(4) Turn on the power using "Power operation ( X )" button.
b When Remote ID Setup mode is running, operations other than the "QUICK SELECT 1 - 4" buttons or "Power
operation ( X )" buttons on the main unit are not received.
b Remote ID can also be set at Setup Menu - General - Remote ID.
R e s t a r t
R E M O T E
R E M O T E
R E M O T E
R E M O T E
R E M O T E
I D ?
FL Display
I D 1
I D 2
I D 3
I D 4
71