Protection Pass Mode; Cx870 / Cy920 Reboot Mode - Denon AVR-X3100W Service Manual

5. Protection Pass Mode

5.1. Actions
• This mode allows the power to be turned on without activating protections.
• This is the same as normal power-on, except that protections are not activated.
5.2. Operations
Hold down buttons "TUNER PRESET CH -", "ZONE2 SOURCE" and "STATUS" at the same time and press the power
button to turn on the power.
The device returns to the normal display after the following is displayed.
FLD
P r o t e c t i o n
This is displayed for 5 seconds before returning to the normal display.

6. CX870 / CY920 Reboot mode

6.1. Actions
• The CX870 / CY920 is restarted after CX870 / CY920 hangup.
• The CX870 / CY920 can be restarted even in the network standby setting ("Setup menu" – "Network" – "Network" –
"Always On").
6.2. Operations
1. Turn on the button "MAIN ZONE" and set NETWORK as the input source.
2. Hold down buttons "TUNER PRESET CH +" and "TUNER PRESET CH -" for at least 3 seconds while the power is on.
3. FL display during CX870 / CY920 reboot
FLD
N e t w o r k
4. Returns to the normal display.
NOTE:
• The CX870 / CY920 Reboot operation is not accepted again for one minute after executing the reboot.
• Reception is prohibited during update, save and load.
P a s s
R e s t a r t
65