Henny Penny HC-5 Operator's Manual page 28

3-9. FRONT & REAR OPERATING
CONTROLS-HHC-903-10 CDT
(Continued)
Nov. 2006
2. Press when "
to change the temperature reading from Fahrenheit
to Celsius, or vice-versa.
3. Press and release
4. Press and hold
"in-3, in-2, in-1". When "int SYS" shows in the display,
release the or
The temperature and timers are now programmed to fac-
tory presets.
5. Press and release
followed by the probe temperature, inside the unit.
6. Use to set the displayed temperature to match the
actual temperature inside the unit.
7. Press and release
the display. "P=L" means Locked and the setpoint
temperature and timers CANNOT be programmed. "P=U"
means Unlocked and the setpoint temperature and timers
CAN be programmed. Use the
from
"P=L" to "P=U" or vice-versa.
8. Press and release
Use the to toggle the outputs ON & OFF. When the
outputs are ON, the HEAT ON LED should come on and
"8888" shows in the display, indicating the outputs are
working correctly.
9. Press and hold
all modes will now be set.
Model HHC-90X/Model HC-5/15
o o
F" or " C" shows in the display, use
and "int" shows in the display.
or and display counts down,
and the initialization is complete.
and "CAL" shows in the display,
twice and "P= L or U" shows in
to toggle the display
and "OP" shows in the display.
to exit Special Program Mode and
3-15