Henny Penny HC-5 Operator's Manual page 26

3-9. FRONT & REAR OPERATING
CONTROLS-HHC-903-10 CDT
Front Controls
Rear Controls
Nov. 2006
Start-UP
1. Turn the power switch to the ON position.
2. The display shows the increase in temperature, indicating
the unit is heating.
Press and hold
3. When the preset temperature is reached, the "HEAT ON"
LED turns off and display stays at the preset temperature.
Timer Operation
Each of the timers can be started, stopped, or cancelled, and not
affect the status of the other timers.
1. Press the desired timer button, from either the front or rear
of the unit.
2. The time remaining flashes in both front and rear displays.
If #2 timer is started on the front, #2 timer also shows
timing down on the rear of the unit. If more than one
timer is running, the timer with the least amount of time
remaining flashes.
3. At end of time cycle, alarm sounds and "0:00" displays.
4. Press the timer to stop alarm and "---" is displayed.
Press and hold an active timer to cancel.
Vent Adjustment
The vent adjustment on the rear panel limits the humidity level
inside the unit. Sliding the knob to a setting of 5 opens the two
vent holes completely and a setting of 0 closes them.
Model HHC-90X/Model HC-5/15
to view the setpoint temperature.
3-13