Henny Penny HC-5 Operator's Manual page 27

3-9. FRONT & REAR OPERATING
CONTROLS-HHC-903-10 CDT
(Continued)
3-14
Programming Temperature and Timers
1. Press and hold
2. Press to change the flashing setpoint temperature.
If "LOC" shows in the display at this time, the programming
controls are locked and must be unlocked. See Special
Program Mode Section.
3. Press and release
of the timer buttons, on either side of the unit, and when
they are flashing, use
and seconds. If a timer is flashing on one side of the unit,
the corresponding timer on the other side of the unit also
flashes. For example, if timer #2 on the front of the unit
is flashing, #2 on the rear of the unit also flashes. So, both
front and rear timers are programmed at the same time.
More than one timer can be programmed at the same time
if they are to be programmed with identical times. Just
press the timers to be programmed and when they are all
flashing, use
front and reartimers will be programmed.
4. Press and hold
settings are now programmed.
SPECIAL PROGRAM MODE
This mode consists of:
• Fahrenheit or Celsius Programming
• Initialize System - One button programming for times and
temperatures
• Probe Calibration
• Locking or Unlocking Programming
• Outputs Test
1. Turn power switch OFF and press and hold
"SP" shows in the display, followed by the software
version.
Model HHC-90X/Model HC-5/15
until "Prog" shows in the display
to program the timers. Press any
to set the timer in minutes
to set the time in all timers. Again, both
to exit the Program Mode and all
until
Nov. 2006