Battery Saver - Kenwood ProTalk NX-P500 User Manual

BATTERY SAVER

This transceiver has been designed to give you the most out of your battery
power. The battery saver function decreases the amount of power used when a
signal is not being received and no operations are being performed.
While using the transceiver, battery saver will automatically switch ON after
5 seconds have elapsed with no operations or received calls. Operating the
transceiver or receiving a call will switch this feature OFF until 5 seconds of non-
operation occurs again.
To turn this function on or off:
1
Enter the Setting mode {p.30}.
2
Press the button programmed as [Channel Up] or [Channel
Down] to select "
3
Press the button programmed as [Channel Menu] then press the button
programmed as [Channel Up] or [Channel Down] to select your desired
value.
Short
Medium
4
Press the button programmed as [Channel Menu] to confirm the selection,
then press the PTT switch or the Side button to exit to the operation mode.
Note:
◆ While the Battery Saver is operating, the beginning of the received voice may be cut off.
".
OFF The Battery Saver function is deactivated.
The Battery Saver function is activated and checks the presence
or absence of the signal at 200 ms intervals.
The Battery Saver function is activated and checks the presence
or absence of the signal at 400 ms intervals.
The Battery Saver function is activated and checks the presence
Long
or absence of the signal at 800 ms intervals.
39