Backlight - Kenwood ProTalk NX-P500 User Manual

BACKLIGHT

You can set the display backlight to remain off, remain on, or turn on when
you press any button other than the PTT switch (auto). When set to "
backlight remains on for 5 seconds after pressing a button, before turning off
again.
To select the backlight setting:
1
Enter the Setting mode {p.30}.
2
Press the button programmed as [Channel Up] or [Channel
Down] to select "
3
Press the button programmed as [Channel Menu] then press the button
programmed as [Channel Up] or [Channel Down] to select your desired
value.
Active
4
Press the button programmed as [Channel Menu] to confirm the selection,
then press the PTT switch or the Side button to exit to the operation mode.
".
OFF The backlight does not light up.
The Button operation lights the backlight.
• It does not light with the following button operation:
PTT switch / Calling Alert / CW Message / Monitor / Monitor
Momentary / Squelch Off / Squelch Off Momentary
When the speaker is muted, when the signal is received, the
Any
backlight will light.
ON The backlight always lights up.
38
", the