Battery Saver - Kenwood TH-225A Instruction Manual

If the channel is busy, the ЕШ] indicator
BEEP function is ON, a beep will sound.
ks, and if the
To stop the function, press the С] and 1/PRIO keys
again.
The function does not operate during scan or transmission.
E BATTERY SAVER
Battery Saver operation provides to turn ON or OFF battery
power automatically during reception and thus extend oper-
ation t i m e .
2 ACTIVATION MODES
1. SAVE MODE: The transceiver will activates the battery
saver circuit 2 seconds after the squelch closes.
2. AUTO SAVE MODE: The transceiver will activates the
battery saver circuit 1 minute after the last key oper:
tion during the squelch closes.
To select the desired Battery Saver Mode, press the ex]
key. Each time press the key, radio wil advance from SAVE
to AUTO SAVE to OFF.
The indicator will light;
SAVE MODE : SAVE
AUTO SAVE MODE : [AUTO AVE
OFF 2 No indicator
Power Save Ratio Selection
To alter the actual length of time the receiver section shuts
down, press the С key and then the E] key. The dis-
play will show the time the radio will be operating at reduced
power levels (Ex. 1 : 1).
Use the [2] or the С]
key to select the desired
save ratio from 1:1 to
1:9.
Press the [EE] key to complete the selection.
The radio will operate at reduce power consumption accor-
ding to the accompanying diagram.
For example;
vec s Ир
ON о
[К
.—] means
оч оғ
50.3 SEC
When a signal is received, the function is automatically can-
celled.
'Since the receiver section shuts down, the squelch may not
open by pressing the MONITOR switch.
7