Table of Contents
Advertisement
cleaning
Many household cleaners contain abrasives and chemical substances, and should
not be used for cleaning plated or plastic fittings. These finishes should be cleaned
with a mild washing up detergent or soap solution, and then wiped dry using a soft
cloth.
1.
Use your thumb or a soft cloth to wipe
any limescale from the soft rubber
nozzles and the front face of the
spray plate assembly
sprayplate must be regularly cleaned
to make sure that the showerhead
does not become blocked.
the trouble shooting information tabled below gives details on what you can do as
a user, should you encounter difficulties with the shower fittings whilst operating
the shower. Before replacing any parts make sure that the underlying cause of the
malfunction has been resolved.
malfunction
No flow or low flow
rate from shower
fittings.
Drip from spray
plate assembly in
Showerhead.
Shower temperature
changes when spray
action is adjusted.
maInTenance
Important!
the
FaulT dIaGnoSIS
cause
Spray plate blocked.
hose blocked or twisted.
Problem with shower control.
a small amount of water may
be retained in the shower
fitting after the shower control
has been turned off. this may
drain over a few minutes.
adjusting the spray action
changes the flow of water.
this may affect some shower
c o n t r o l s a n d p l u m b i n g
installations.
refer to section
'maintenance, cleaning'.
clear blockage or release
twist in hose or renew hose.
refer to the shower control
Installation and User Guide.
this is quite normal. changing
the angle of the showerhead
may vary the draining time.
to minimise the effect make
sure that the spray plate
is clean. refer to section:
'maintenance, cleaning'.
If the malfunction persists
refer to the shower control
Installation and User Guide.
10
remedy
Advertisement
Table of Contents
