Advertisement
7. Fit the shower arm into the compression nipple
and tighten the compression nut.
Olive
Concealing
Shroud
8. Hand tighten the concealing shroud onto the
backplate.
9. Screw the deluge head onto the shower arm,
if necessary fit the flow regulator.
Important! Certain mixing valves may have
flow regulators, refer to your shower control
installation and user guide for details.
Caution! The shower arm is not designed to
take weight, therefore care needs to be taken
when installing the deluge head.
Flow Regulator
(some models)
10. Turn on the shower control and check for leaks.
Alternative Installation procedure
using the wallplate
1. Loosely screw the backplate to the wallplate
with the two backplate screws provided.
2. Place the wallplate and backplate assembly
over the copper pipe.
3. Mark the position of the wallplate and its fixing
holes on the wall.
Copper Pipe
Backplate
Screw
Compression
Nut
Shower
Arm
Shower Arm
Deluge Head
Backplate
6 mm Recess
4. Remove the screws and backplate from the
wallplate.
5. Drill the two backplate fixing holes, if necessary
make a recess approximately 6 mm deep to
accept the wallplate. Plug the two fixing holes.
6. Place the wallplate over the copper pipe and
fix to the wall with the two wallplate screws.
7. Temporarily fit the two backplate screws to
the wallplate. This will prevent the holes from
becoming blocked with plaster and grout.
8. Finish the surface of the wall as required ensuring
the pipework is protruding by 18 mm ± 2 mm.
9. Remove the two backplate screws.
10. Place the backplate against the finished wall
surface and use the two backplate screws
supplied to fix the backplate to the wallplate.
11. Follow steps 4 - 9 from previous section to
complete the shower arm installation.
MAINTENANCE
Cleaning
Warning! Many household cleaners contain
abrasive and chemical substances, and should not
be used for cleaning plated or plastic fittings.
These finishes should be cleaned with a mild
washing up detergent or soap solution, and then
wiped dry using a soft cloth.
Use your thumb or a soft cloth to wipe any
limescale from the soft nozzles and the front
surface of the showerhead spray plate.
Do not use descalents on this product.
SPARE PARTS
1799.009
Shower Arm
Deluge Head
1660.161 - Mira 18.5 cm (Chrome)
1799.007 - Mira Beat 20 cm (Chrome
1799.008 - Mira Beat 25 cm (White/Chrome)
1656.131
Backplate Assembly
1656.132
Concealing
Shroud
Advertisement
