Connecting To Your Cradle Again - Argox AR-3201 User Manual

3. Push the "Reset" button on the bottom
of cradle – If the cradle is
linked with an imager and in
range, pushing the "Reset"
button (for about 2 seconds) on
the bottom of cradle will drop
the link between the devices. If
the button is pushed while the
imager is out of range, the cradle will
unlink and make itself available to other
imagers. The scanner will not drop its link
with the cradle automatically, but can be
linked to any other cradle by reading its
link label.
* Note: If just push the button with a short time
(less than one second), a "Paging" feature will
be performed to page the imager which was
linked with the cradle.

2.3.3 Connecting to your cradle again

If your scanner has connected to other device,
and you want it to connect to your cradle
again, do this:
1. Scan the following bar code.
2. Scan the bar code at the bottom of your
cradle.
15