Connection; Connecting The Scanner With The Cradle - Argox AR-3201 User Manual

2.3 Connection

Your scanner can connect to three types of
devices: your cradle, a Bluetooth adapter or a
mobile device.
2.3.1 Connecting the Scanner with the
Cradle
Follow these instructions to link the two
devices:
1. Connect power to the cradle. The radio
LED (marked with a light symbol) will
blink amber and the cradle will beep.
2. To ensure the cradle is unlinked from any
other imager, check if the cradle sends an
inquiry beep or not (see Inquiry Beep
Control in page 24
3. Read the link label on the bottom of the
cradle with the imager. The imager will
sound a good read beep and the LED will
flash amber.
4. Re-place the imager in the cradle to
continue the charge.
Once a scanner is linked to a cradle, they will
remain linked until specific action is taken to
unlink them (see Unlinking). They will remain
linked if the cradle is unplugged, if the battery
is removed from the imager or if the entire
charge is used up, and if the imager is taken
out of range of the cradle. Under normal
operation, scanning of the link label will only
be required once in the life of the product.
th
).
13