Disconnecting The Scanner From The Cradle - Argox AR-3201 User Manual

2.3.2 Disconnecting the Scanner from
the Cradle
There are three ways to unlink an imager from
a cradle:
Force imager to disconnect and sleep
1. Scan the "Force imager to disconnect
and sleep" barcode – Reading the unlink
barcode above while the imager is in range
of the cradle will break the link between
the two devices and allow another imager
to link to the cradle. It will also have the
imager in Deep Sleep Mode. If the
barcode is read when the imager is out of
range of its linked cradle, the imager will
unlink, but the cradle will remain linked to
the imager and will not allow another
imager to be linked to it. In this case, you
may perform the item 2 below to link
another imager.
2. Scan the Link Label on an alternate
cradle – Scanning the link label on a
cradle will drop the link between the
original pair and establish a link between
the imager and new cradle. If the new link
is performed within range of the old cradle,
it is free to establish a link to the next
imager that reads its link label. If it is done
outside of the range of the old cradle, it
retains its old link and will not allow a
new imager to link to it until a new imager
scan the link label and put on the cradle.
14