Get Started; Installation; Set Up Your Scanner - Argox AR-3201 User Manual

2

Get started

This chapter provides information about how
to install, connect and use your scanner to do
your work, and how to charge and replace
your battery.

2.1 Installation

This section describes how to set up your
scanner.

2.1.1 Set up your scanner

1. Connect one end (RJ-45
2. Connect the other end of the USB or the
Charging by
Power Supply
USB Cable
3. Place your scanner on your cradle to
4. Scan the Cradle code at the bottom of
connector) of the USB or
the RS-232 cable to your
cradle. Lay the cable into
the notch on the cradle
edge.
RS-232 cable to your computer.
Note 1 If you've purchased the USB
pack, you can charge your scanner by
connecting the USB cable to your
computer.
Note 2 If you've purchased the RS-232
pack, connect the power supply to the
RS-232 cable and the wall outlet.
charge it to full (cradle's LED glows
green).
your cradle to establish the connection
between your scanner and cradle.
Full Charge Time
4.5 hours
6.5 hours
7