Configuring Initial Settings On The Control Panel; Setting Up The Printer Using Quick Setup (Windows ® Only) - Fuji Xerox DocuPrint P505 d User Manual

Setting Up the Printer (Printer Setup)

Configuring Initial Settings on the Control Panel

When you turn on the printer for the first time, the install wizard screen to perform the
initial setup appears on the control panel. Follow the wizard to configure the initial settings,
including the following:
 Language
See "Language" (P.76).
Date & Time

See "Date & Time" (P.77).
 Measurements
See "Measurements" (P.77).
The printer is ready for use after tapping [Done] on the [Install Complete] screen that
appears at the end of the settings.
2
Setting Up the Printer Using Quick Setup (Windows
Note


Basic Setup
To set up the printer, you can use the setup program on the computer running a Microsoft
Windows
The program first searches for the printer and grasps how the printer is connected to the
computer. Based on that information, the program will automatically install the drivers and
software to your computer.
Before starting this basic setup, make sure that the printer is turned on, and ensure the
cable connections as follows:
To set up the printer as a network (wired) printer, connect the Ethernet cable to the

printer.
 To set up the printer as a USB printer, connect the USB cable to the printer.
Note

1
Insert the Software/Product Manual disc provided with the printer into your computer.
The setup program launches automatically and begins to search for your printer.
Note

1) Right-click the Start button, and then click [Run].
2) Enter [D:\Launcher.exe] (where [D] is the drive letter of the optical drive), and then click
[OK].
18
To set up the printer as a wireless printer, see "Configuring the Wireless Settings" (P.19).
To set up the printer connected with Macintosh computers, see "Installing Printer Drivers on Computers"
(P.27).
®
operating system.
To enable the automatic search for network printers on the computer running a client operating system
® ®
(Windows 7, Windows 8.1 or Windows
and Sharing Center] > [Advanced sharing settings], and set [Network discovery] for the current network
profile to [Turn on network discovery].
If the setup program does not launch automatically, follow the procedure below.
The following procedure uses Windows
®
®
10), go to [Control Panel] > [Network and Internet] > [Network
®
10 as an example.
Only)
®