Verify Alarms - Cisco NCS 1002 System Setup And Software Installation Manual

Perform Preliminary Checks
• Verify whether the management interface is in the no shut state using the show running-config interface

Verify Alarms

You can view the alarm information using the show alarms command.
Procedure
show alarms [ brief [ card | rack | system ] [ location location ] [ active | history ] | detail
[ card | rack | system ] [ location location ] [ active | clients | history | stats ] ]
Displays alarms in brief or detail.
Example:
RP/0/RP0/CPU0:ios# show alarms brief card location 0/RP0/CPU0 active
Thu Mar
------------------------------------------------------------------------------------
Active Alarms
------------------------------------------------------------------------------------
Location
------------------------------------------------------------------------------------
0/0
Is Provisioned Without K9sec Package Or K9sec Package Incomplete
0/0
Improper Removal
0/0
Improper Removal
0/0
Improper Removal
0/0
HundredGigECtrlr0/0/0/11 - Remote Fault
mgmtEth command.
The following example shows sample output from the show running-config interface mgmtEth
command.
RP/0/RP0/CPU0:ios#show running-config interface mgmtEth 0/RP0/CPU0/0
Fri Nov 13 19:42:54.368 UTC
interface MgmtEth0/RP0/CPU0/0
ipv4 address 10.58.227.183 255.255.255.0
!
In the above output, the management interface is in the no shut state.
8 17:51:47.237 UTC
Severity
Minor
Critical
Critical
Critical
Major
Group Set Time
Slice 03/07/2018 07:33:43 UTC
Controller 03/07/2018 07:37:19 UTC
Controller 03/07/2018 07:38:17 UTC
Controller 03/07/2018 07:38:17 UTC
Ethernet 03/07/2018 08:36:11 UTC
System Setup and Software Installation Guide for Cisco NCS 1002

Verify Alarms

Description
Encrypted Slice
Optics0/0/0/10 -
Optics0/0/0/2 -
Optics0/0/0/3 -
29