Cisco NCS 1002 System Setup And Software Installation Manual page 22

Verify Status of Hardware Components
--------------------------------------------------------------------------------
0/RP0/CPU0
a) If the Cisco IOS XR is not operational, no output is shown in the result. In this case, verify the state of
service domain router (SDR) on the node using the show sdr command in Cisco IOS XR mode.
The following example shows sample output from the show sdr command in Cisco IOS XR mode.
RP/0/RP0/CPU0:ios# show sdr
Wed Feb 28 03:28:45.845 UTC
Type
--------------------------------------------------------------------------------
RP
NCS1K-CNTLR
Step 2
admin
Enters System Admin EXEC mode.
Example:
RP/0/RP0/CPU0:ios# admin
Step 3
show platform
Displays information and status for each node in the system.
Example:
sysadmin-vm:0_RP0# show platform
Wed Feb
Location
----------------------------------------------------------------------------
0/0
0/RP0
0/FT0
0/FT1
0/FT2
Verify that all components of the NCS 1002 are displayed in the result. The software state and the hardware
state must be in the OPERATIONAL state. The various hardware and software states are:
Hardware states:
• OPERATIONAL—Node is operating normally and is fully functional.
• POWERED_ON—Power is on and the node is booting up.
• FAILED—Node is powered on but has experienced some internal failure.
• PRESENT—Node is in the shutdown state.
• OFFLINE—User has changed the node state to OFFLINE. The node is accessible for diagnostics.
Software states:
• OPERATIONAL—Software is operating normally and is fully functional.
• SW_INACTIVE—Software is not completely operational.
• FAILED—Software is operational but the card has experienced some internal failure.
System Setup and Software Installation Guide for Cisco NCS 1002
18
NCS1K-CNTLR(Active)
NodeName
0/RP0/CPU0
0/RP0
28 03:31:53.672 UTC
Card Type
NCS1002-K9
NCS1K-CNTLR
NCS1K-FTA
NCS1K-FTA
NCS1K-FTA
IOS XR RUN
NodeState RedState
IOS XR RUN ACTIVE
OPERATIONAL
HW State SW State
OPERATIONAL N/A
OPERATIONAL OPERATIONAL
OPERATIONAL N/A
OPERATIONAL N/A
OPERATIONAL N/A
Perform Preliminary Checks
NSHUT
PartnerName
NONE
N/A
Config State
NSHUT
NSHUT
NSHUT
NSHUT
NSHUT