Cisco NCS 1002 System Setup And Software Installation Manual page 50

Change Disaster-recovery Username and Password
Enters System Admin Config mode.
Step 3
aaa disaster-recovery username username password password
Example:
sysadmin-vm:0_RP0#(config)#aaa disaster-recovery username us1 password pwd1
Specify the disaster-recovery username and the password. You have to select an existing user as the
disaster-recovery user. In the example, 'us1' is selected as the disaster-recovery user and assigned the password
as 'pwd1'. The password can be entered as a plain text or md5 digest string.
When you need to make use of the disaster recovery username, you need to enter it as username@localhost.
Step 4 Use the commit or end command.
commit-Saves the configuration changes and remains within the configuration session.
end-Prompts user to take one of these actions:
• Yes-Saves configuration changes and exits the configuration session.
• No-Exits the configuration session without committing the configuration changes.
• Cancel-Remains in the configuration session, without committing the configuration changes.
System Setup and Software Installation Guide for Cisco NCS 1002
46
Create User Profiles and Assign Privileges