Cisco NCS 1002 System Setup And Software Installation Manual page 30

Verify Firmware Version
TenGigECtrlr0/0/0/0/1
TenGigECtrlr0/0/0/0/2
TenGigECtrlr0/0/0/0/3
TenGigECtrlr0/0/0/0/4
TenGigECtrlr0/0/0/1/1
TenGigECtrlr0/0/0/1/2
TenGigECtrlr0/0/0/1/3
TenGigECtrlr0/0/0/1/4
TenGigECtrlr0/0/0/2/1
TenGigECtrlr0/0/0/2/2
TenGigECtrlr0/0/0/2/3
TenGigECtrlr0/0/0/2/4
TenGigECtrlr0/0/0/3/1
TenGigECtrlr0/0/0/3/2
TenGigECtrlr0/0/0/3/3
TenGigECtrlr0/0/0/3/4
TenGigECtrlr0/0/0/4/1
TenGigECtrlr0/0/0/4/2
TenGigECtrlr0/0/0/4/3
TenGigECtrlr0/0/0/4/4
In the above output, DP FPGA Version indicates the image of the datapath FPGA. Here, F-203 is the image
version of the 40 G image. The CURRENT value of the HW Status parameter indicates that the firmware
version is the latest.
When the DP FPGA Version is T, it indicates 10 G. If the DP FPGA Version is H, it indicates 100 G image
versions. If Need UPG appears in the output, you must upgrade the slice to get the updated DP FPGA using
the upgrade hw-module slice slice_number re-provision command.
What to do next
Upgrading the Firmware Version of Hardware Components
Notes for Release 6.0.1
• You can upgrade the firmware version of the power modules, BIOS, CFP2, or Coherent DSP of the NCS
1002. For details on upgrading the firmware version of the power modules, see
Version of Power Modules, on page 58
• You can upgrade both BIOS_Primary and BIOS_Backup.
• You can upgrade the BIOS_Backup only if the Programmed FPD version of the Daisy Duke FPGA is
0.15. If the FPD version of the Daisy Duke FPGA is not 0.15, the state of the BIOS_Backup is NOT
READY state.
Use this procedure to upgrade BIOS_Backup.
1. Upgrade Daisy Duke FPGA.
2. Use the reload command to activate Daisy Duke FPGA.
3. Use the upgrade command to upgrade BIOS_Backup separately.
Use the show fpd package command to display the FPD image version available with this software release
for each hardware component.
sysadmin-vm:0_RP0# show fpd package
Wed Feb
System Setup and Software Installation Guide for Cisco NCS 1002
26
28 03:35:19.382 UTC
Perform Preliminary Checks
100 0
100 0
100 0
100 0
100 0
100 0
100 0
100 0
0 100
0 100
100 0
100 0
0 100
0 100
0 100
0 100
0 100
0 100
0 100
0 100
Upgrading the Firmware