Furuno MU-190 Operator's Manual page 18

1. MOUNTING, WIRING
2. Set the mounting bracket to the mounting location with four self-tapping screws.
3. Attach the bracket support to the rear of the monitor unit with the binding head screws (9 pcs.).
4. Connect all cables at the back of the monitor unit. See section 1.8.
5. Loosen the knobs of the bracket support and set knobs in the notches on the mounting brack-
et.
6. Adjust the angle of the monitor unit and fix the knobs tightly.
How to attach the hood
You can attach a hood to the tabletop-mounted monitor unit, using the hood assembly OP26-6
(option).
1. Follow steps 1 to 3 in section 1.6.
2. Fix the hood fixing plates 19 to the right and left of the monitor unit with the flat head screws
(6 places). (See step 2 in section 1.5.)
3. Follow steps 4 to 5 in section 1.6.
4. Follow steps 5 to 8 in section 1.5.
Self-Tapping Screw
(4 places)
Mounting Bracket (19)
Bracket Support w/Knobs
Mounting Bracket (19)
Binding Head Screw (9 places)
Binding Head
Screw
Knob
9
Rear view