Solid-State Drive Board - HP 15 Maintenance And Service Manual

Solid-state drive board

Table 5-8 Solid-state drive board and cable descriptions and part numbers
Description
Solid-state drive board
Solid-state drive cable
Before removing the solid-state drive board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drive (see
Remove the solid-state drive board:
1. Disconnect the cable from the ZIF connector on the solid-state drive board (1).
2. Remove the three Phillips M2.0 × 2.8 screws (2) that secure the board to the computer.
3. Remove the solid-state drive board from the computer (3).
Reverse this procedure to install the solid-state drive board.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page 32).
Solid-state drive on page
29).
30).
37).
Spare part number
L52026-001
L52025-001