3.8
Control Panel
3.8.1
General Description
The control panel consists of button switches and touch-panel switches to operate the equipment and
select various modes, and LEDs and an LCD to display the state of the equipment or the messages.
When the operator's attention is required, graphic symbols light or blink with messages explaining the
condition of the equipment in the LCD panel. When paper jams and "Call for service" occur, error codes
are also displayed to notify users of the problem.
A color LCD is used in this equipment so that visibility and operability are improved.
This equipment has an LCD larger than those of our existing models and an arm to attach the control
panel. This arm enabled the height adjustment and the angular adjustment in both vertical and
horizontal directions of the control panel so visibility and operability of the control panel has been
greatly improved.
And the [ON/OFF] button is placed on the control panel of this equipment. Use this button instead of the
main power switch to turn ON/OFF the power.
Press the [ON/OFF] button for 1 second or more to turn ON/OFF the power of the equipment.
Also, the [ON/OFF] button can be used in the following manner for example: press the [ON/OFF] button
while holding down the [0] and [5] buttons simultaneously to activate the Adjustment Mode (05).
However, if the equipment is in the super sleep mode, use the main power switch.
Control Panel: e-STUDIO5540C/6540C/6550C
Fig. 3-30
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
3 - 58