Table of Contents
Advertisement
7.3 Procedure in case of fault
Building Technologies
Fire safety
MINOR INCIDENT: No fire alarm
The fire alarm reoccurs if any device remains in fire condition.
A fault event is displayed on LCD if a fault occurs.
As an option, the configured outputs can be activated (example, RT fault).
1. Press
on the PMI.
2. Read message / fault location on the display.
3. Go to the fault location.
4. Eliminate the cause of the fault.
A list of possible faults and solutions can be found in the chapter 'Trouble
shooting [➙ 109]'. Please contact your service provider if the fault cannot be
eliminated.
The fault is reported again if it is acknowledged but not eliminated.
Procedure in case of fault
Press <Reset>
to return into normal
operation.
(Access level 2 password is required.)
Check
and ensure that the fire brigade was not
called accidently
Operation
7
67 | 124
A6V10421795_en--_g
2016-11-18
Advertisement
Table of Contents
