Table of Contents
Advertisement
Building Technologies
Fire safety
Modify using 'FC360 Desktop Editor'
1. Connect the panel to the PC installed with 'FC360 Desktop Editor'.
2. Backup configuration to PC first. Refer to chapter 'Backup configuration to PC
[➙ 104]'.
3. Open 'FC360 Desktop Editor'.
4. Select language and click 'Enter'.
5. Click 'Open an existing configuration'.
6. Select the file name of backup configuration and click 'Open'.
a The configuration is open in 'FC360 Desktop Editor'.
7. Modify configuration as needed.
a Generally the following configuration needs to be modified:
–
Customer texts
–
Properties and the parameters
–
Allocation of zones and sections
–
Control logics
8. After finishing modification, click 'Save as' to save the modified configuration.
9. Restore the configuration to the panel by 'FC360 Panel Configurator'. Refer to
chapter 'Restore configuration to panel [➙ 104]'.
a The panel restarts automatically if the panel is in access level 3.
a The configuration finishes.
Detailed information about operation of 'FC360 Panel Configurator' and 'FC360
Desktop Editor' is available in document A6V10450595. Refer to chapter
'Applicable documents [➙ 9]'.
The topology must not be changed (e.g. add or delete devices on the detector
line) when using the 'FC360 Desktop Editor' to modify the configuration.
Otherwise you will fail in downloading the configuration.
Commissioning
General commissioning steps
A6V10421795_en--_g
9
99 | 124
2016-11-18
Advertisement
Table of Contents
