National Instruments PCI E Series Programmer's Manual page 87

Chapter 4 Programming
PCI E Series RLPM
Joint_Reset_Register
AI configuration start = 0;
AI configuration end = 1;
6. The function
AI_Scan_Start
Joint_Reset_Register
AI configuration start = 1;
AI_START_STOP_Select_Register = 0x0060;
AI_SI_Load_A_Registers (24 bits)
AI SI special ticks -1 = 1;
AI_Command_1_Register
AI SI load = 1;
AI_SI_Load_A_Registers (24 bits)
AI SI ordinary ticks -1 = 19999;
Joint_Reset_Register
AI configuration start = 0;
AI configuration end = 1;
7. Perform Analog Input Example 1 Step 11.
8.
Convert_Signal
Joint_Reset_Register
AI configuration start = 1;
AI_SI2_Load_A_Register
AI SI2 special ticks -1 = 1999;
AI_SI2_Load_B_Register
AI SI2 ordinary ticks -1 = 1999;
AI_Mode_2_Register
AI SI2 reload mode = 1;
AI_Command_1_Register
AI SI2 load = 1;
AI_Mode_2_Register
AI SI2 initial load source = 1;
Joint_Reset_Register
AI configuration start = 0;
AI configuration end = 1;
9. Perform Analog Input Example 1 Step 4.
selects the scan start event.
selects the convert signal for the acquisition.
4-24 © National Instruments Corporation