National Instruments PCI E Series Programmer's Manual page 56

1
0
© National Instruments Corporation
PCI-6024E, PCI-6025E, and PCI-6031E. It should be set
to 0.
ReGlitch Reglitch DAC—When set, this bit configures the selected
DAC to have a more uniform glitch when changing the
output at the expense of a higher average glitch energy.
This bit is reserved on the PCI-MIO-16E-4,
PCI-MIO-16XE-50, PCI-MIO-16XE-10, PCI-6032E, and
PCI-6031E. It should be set to 0.
BipDac Bipolar DAC—This bit configures the voltage range of the
selected DAC. If this bit is set, then the DAC is configured
for bipolar operation of –V
written to the DAC is interpreted in two's complement
format. If this bit is cleared, then the DAC is configured
for unipolar operation of 0 V to +V
written to the DAC is interpreted in straight binary format.
This bit is reserved on the PCI-MIO-16XE-50 and should
be set to 1. The PCI-MIO-16XE-50, PCI-6024E, and
PCI-6025E DACs are always configured in bipolar mode.
Chapter 3
ref
3-17
Register Map and Descriptions
to +V . In this mode, data
ref
. In this mode, data
ref
PCI E Series RLPM