Grizzly G0852 Owner's Manual page 20

13. Attach collection bag lid to lower legs using
(4) ⁄ "-18 x ⁄ " hex bolts and (4)
5 3
16 4
washers (see Figure 20).
Collection
Bag Lid
x 4
Figure 20. Collection bag lid attached to lower
legs.
14. Final-tighten all fasteners installed in Steps
11–13 in a star pattern.
15. Place rubber gasket on 6" dust intake port,
then attach to motor/impeller housing using
(6) ⁄ "-20 x ⁄ " hex bolts and (6)
1 3
4 4
ers (see Figure 21). Tighten in star pattern.
16. Place rubber gasket between exhaust port
and motor/impeller housing, then attach using
(4) ⁄ "-18 x ⁄ " hex bolts and (4)
5 3
16 4
washers (see Figure 21).
17. Attach switch box to motor/impeller housing
using (2) ⁄ "-18 x
5
16
fender washers (see Figure 21).
Switch
Box
x 2
x 6
Dust Intake Port
Figure 21. Dust intake port, exhaust port, and
switch box attached to motor/impeller housing.
-18-
⁄ " fender
5
16
⁄ " flat wash-
1
4
⁄ " fender
5
16
⁄ " hex bolts and (2)
3 5
4
Exhaust
Port
x 4
Motor/
Impeller
Housing
18. Attach motor/impeller housing using (4)
18 x ⁄ " hex bolts and (4)
3
4
on base stand, and (2)
and (2)
5
leg (see Figure 22).
x 2
x 4
Figure 22. Motor/impeller housing attached to
base stand and lower left front leg.
19. Place 6 ⁄
1
vacuum hose, then connect hose to motor/
impeller housing exhaust port and intake
barrel (see Figure 23). Tighten clamps to
secure.
⁄ "
16
Figure 23. 6" vacuum hose attached to intake
barrel and impeller housing exhaust port.
⁄ " fender washers
5
16
⁄ "-18 x
5
16
⁄ " fender washers on lower left front
16
" hose clamp on each end of 6 X 33"
2
Model G0852 (Mfd. Since 12/18)
⁄ "-
5
16
⁄ " hex bolts
3
4
Intake
Barrel
Vacuum
Hose
Motor/
Impeller
Housing
Exhaust
Port