Setting The Programmed Operation Timer - Rinnai PEPH-10PEW Operation & Installation Manual

HOW TO OPERATE THE HEATER

Setting The Programmed Operation Timer

1. To set the ON and OFF timer periods for the heater press the PROG button
Operation indicator will begin to flash.
12
2. Press the 'Up'
4
the down button to make the selected block an OFF block (the heater will be OFF at this time), each press
5
moves the selection on to the next available block cycling from left to right.
3. To save the timer settings press the PROG button
If after 60 seconds no buttons are pressed the heater will revert back to the current operating
setting. Simply press the PROG
NOTE
If the appliance is turned off using the power button
If the appliance is turned off using the main power switch
will require re-setting.
4. Once the timer has been programmed, the heater will automatically turn ON and OFF and heat to the set
temperature for the set times.
5. To edit the timer settings press the PROG button
or 'Down' buttons. To save the new timer settings press the PROG button
4 5
6. To stop Timer operation press the POWER button
Rinnai
11 B
9
button to make the selected block an ON block (the heater will be ON at this time) or press
8
8
A 12
Timer time
block details
Use
Use
Example shows that the heater is set to
be ON at 05:00 to 09:00 & 16:00 to 22:00
.
8
button to re-enter the timer setting operation.
the timer settings will be saved.
2
then change the state of the desire block(s) press the 'Up'
8
.
2
10
6
4
5 2
Time block states
Heater OFF
Heater ON
Heater OFF
4
to select ON Blocks
5
to select OFF Blocks
. The first time block of the Timer
8
then the timer settings will be lost and
1
.
8
PEPH_OIM