Table of Contents
Advertisement
INSTALLATION
4. Secure the mounting bracket to the wall with the 4 mounting screws. For masonry walls use the plastic plugs
with screws provided. For plaster walls obtain suitable plasterboard fasteners from a building hardware supplier.
5. Re-attach heater to the mounting bracket (reverse method of step 2.) and secure with the locking screw(s).
6. Remove the cable tie from the flexible cord and insert the 2 pin plug of the heater into the power socket outlet.
DO NOT bundle or coil the flexible cord to reduce it's length as overheating and subsequent fire hazard could
result.
FREESTANDING INSTALLATION
D
1.
Be sure heater is unplugged and power switches are off.
2. Place the heater in an 'upside down' position with the back of the heater facing you.
3. Assemble the 2 castors
4. With the front end of the castor support bracket pointed towards the front of the heater, align the four locating
tabs
with the four of the outer most air inlets
C
with the heater. Then secure each of the castor brackets in place with retaining screws
5. Remove the cable tie from the flexible cord and insert the 2 pin plug of the heater into the power socket outlet.
DO NOT bundle or coil the flexible cord to reduce it's length as overheating and subsequent fire hazard could
result.
Rinnai
Rotate latch to lock, tighten
locking screw to secure
PEPH15PEW
PEPH10PEW
E
A
A
Front of castor bracket
B
to the each castor bracket
A
Back of heater
Back of heater
by pushing the metal shaft fully home.
B
then push down and forward until the tabs are fully engaged
D
14
Depress screw to insert, tighten
locking screw to secure
PEPH22PEW
Front of heater
C
, using two for each.
E
PEPH_OIM
Hide quick links:
Advertisement
Table of Contents
