Table of Contents
Advertisement
Control Panel Operation
General operation
Turning the unit on and off
Press and hold the ON/OFF button until the unit beeps.
When turning the unit on it will start the electronic spark. The pilot will ignite first followed by
the plaques (approximately 10 seconds). The heater will start on the high setting.
Low and high setting
Press either LOW or HIGH until the unit beeps.
Standby
To turn to pilot only press STANDBY until the unit beeps. This function is not used in the day to
day operation of the appliance.
Power supply and battery replacement
The heater has a dual power supply option and can operate via a 9 V - 2.1 mm DC power
socket or 6 x AA batteries.
Important
When using the 9 V power socket ensure that the empty battery housing remains connected so
that contacts cannot touch the case.
Replacing the batteries:
1.
Unscrew the cover on lower panel.
2.
Remove battery housing taking care not to hang the housing in the air by the
electrical connections.
3.
Replace batteries and put back the battery housing and lower panel cover.
Rinnai New Zealand Limited
Electronic Super Ray Operation and Installation:
7
10081-B 02-11
Advertisement
Table of Contents
