Delay Off Timer Operation - Rinnai DEPH-10DTW Operation & Installation Manual

HOW TO OPERATE THE HEATER

DELAY OFF TIMER OPERATION

In addition to temperature controlled operation the heater can also be operated via the use of a delay off timer. This
allows the user to program the heater to operate for a set time period, after which the heater will be returned back
to standby mode.
1. Set the desired operating temperature as per steps 1 through 3 "CONNECTING THE POWER" on page 8.
2. After setting the desired temperature press the MODE button
0.0
will now display
If after 5 seconds no buttons are pressed the
setting. Simply press the MODE button
NOTE
3. Press the 'Up'
3
The delay off timer can be set in 30 minute (
maximum of 24 hours.
4. To exit the delay off timer setting operation either press the MODE button
The Delay Off Timer Set indicator
operation.
If the selected temperature is above that of the current room temperature the red operation indicator
illuminate and the heater will begin to heat the room.
If the selected temperature is less than that of the current room temperature the red operation indicator
go out and the heater will go into a standby state until the room temperature has fallen below the set
temperature, when the heater will then automatically switch on and heat the room.
The two digits
5
and the time remaining of the set delayed off timer period.
5. To cancel delay off timer and return manual operation press 'Up' button
6. To stop heater operation completely press POWER button
power indicator
6
Rinnai
and both the Delay Off Set indicator
or 'Down' buttons to set the required timer operation period.
4
will illuminate steady to indicate that the heater is now in delay off timer
8
on the display panel will alternate every 5 seconds between displaying the set temperature
will remain illuminated to show that the heater has returned to standby mode.
twice. The two digits
2
and the H (time) indicator
8
0.0
display will revert back to the current operating
twice to re-enter the timer setting operation.
2
.5
) increments up to 9.5 hours and then in 1 hour increments to a
, a shutdown falling chime will be heard and the
1
9
8
7
6
5
B
A
14
on the display panel
5
will begin to flash.
12
once or wait 5 seconds.
2
for 5 seconds.
3
12
13
1
2
3
4
will
7
will
7
DEPH_OIM