6X4 Multi-Function Tiller Handle; Multi-Function Tiller Handle Kit (For Us) - Yamaha 2CMH Rigging Manual

6X4 MULTI-FUNCTION TILLER HANDLE

Yamaha prepares the various multi-function tiller handle kits for F30 to F115 and 40 to 90 engines.
For US, the tiller handle kit for F25 is specially prepared.
This handle has the electrical functions which are similar as that of 703 remote control box.
Engine IG switch, Emergency stop switch, PTT switch (top or side location), Neutral switch, Throttle
friction adjuster, Shift lever, Throttle control grip, Variable troll RPM switch, LED warning indicators,
and Warning buzzer are included into the handle.
The 10-pin main harness in the handle will allow to easily connect the electrical system to the
engine.

MULTI-FUNCTION TILLER HANDLE KIT (FOR US)

Two kinds of the size for handle extension bracket, four kinds of the length for 10-pin wire harness
and some kinds of the length for control cables are prepared to install the handle according to the
various engine specifications.
The tiller handle kit (only one specification) is prepared for F40 to F115 and 50 to 90 engines.
The fitting kit is prepared for each engine.
Combine the tiller handle kit with the handle fitting kit due to the applicable model, except F25.
For installation procedure, see the instruction supplied with the kit.
Tiller handle assy
Setup manual
Handle extension
Throttle cable
Shift cable
10-pin harness
Steering friction assy
Installation hardware
Troll PPM switch
Short shift lever
4-2
Tiller handle kit
(Common use f or
50-90 & F40-F115)
Fitting kit for each
model
(Differs on model)